Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

English
Japanese

Translating step 3

Step 3
Prepare an iOpener (or use a hair dryer or heat gun) and heat the face of the watch to loosen the display adhesive.
Soften the display adhesive
  • Prepare an iOpener (or use a hair dryer or heat gun) and heat the face of the watch to loosen the display adhesive.

  • Leave the iOpener on the watch for at least two minutes to fully heat the screen and soften the adhesive holding it to the case.

  • You may need to reheat the iOpener and repeat this procedure several times until the display adhesive softens.

iOpenerを準備して(もしくはヘアドライヤーやヒートガン)、Watch表面を温めて、ディスプレイの接着剤を柔らかくします。

iOpenerをWatchの表面に少なくとも2分間当てて、スクリーンを温めます。

ディスプレイの接着剤が柔らかくなるまで、iOpenerを複数回に渡って温めて、Watchに載せる作業を繰り返す必要があります。

Your contributions are licensed under the open source Creative Commons license.