Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 12 guides that include this step.

English
Spanish

Translating step 2

Step 2
Apply a suction cup to the heated edge of the rear cover, as close to the edge as possible. Pull up on the suction cup with strong, steady force to create a gap between the rear cover and the frame. Depending on the age of your phone, this may be difficult. If you are having trouble, apply more heat to the edge and try again.
Insert an opening pick
  • Apply a suction cup to the heated edge of the rear cover, as close to the edge as possible.

  • Pull up on the suction cup with strong, steady force to create a gap between the rear cover and the frame.

  • Depending on the age of your phone, this may be difficult. If you are having trouble, apply more heat to the edge and try again.

  • Insert an opening pick into the gap.

  • Don't insert the opening pick more than 5 mm into the phone or you risk damaging the internal components.

Aplica una ventosa al borde caliente de la tapa trasera lo más cerca posible del borde.

Tira hacia arriba de la ventosa con una fuerza fuerte y constante para crear un hueco entre la tapa trasera y el marco.

Dependiendo de la edad de tu teléfono, esto puede ser difícil. Si tienes problemas, aplica más calor al borde y vuelve a intentarlo.

Introduce una púa de apertura en el hueco.

No introduzcas la púa de apertura más de 5 mm en el teléfono o corres el riesgo de dañar los componentes internos.

Your contributions are licensed under the open source Creative Commons license.