Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 27 guides that include this step.

English
Dutch

Translating step 1

Step 1
Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.
Remove the screws securing the lower case
  • Before starting this procedure, you should disable your Mac's Auto Boot feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. Use this guide to disable Auto Boot.

  • If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you're inside.

  • Completely power off and unplug your MacBook Air before you start. Close the display and flip the entire laptop upside-down.

  • Use a P5 driver to remove the following screws:

  • Two 7.9 mm screws

  • Two 7.1 mm screws

  • Six 2.6 mm screws

Je zult, voordat je met deze procedure begint, de Auto Boot-functie van je Mac uit moeten schakelen. Auto Boot schakelt zich in als je het scherm van je MacBook opent en kan per ongeluk worden geactiveerd tijdens het demonteren van je laptop. Gebruik deze handleiding of volg de ingekorte instructies hieronder om Auto Boot uit te schakelen.

Schakel je MacBook Air uit en haal deze van de oplader voordat je met deze reparatie begint. Sluit het scherm en draai de laptop om zodat deze met de onderkant naar boven wijst.

Gebruik P5-schroevendraaier om de volgende schroeven te verwijderen:

Twee 7.9 mm lange schroeven

Twee 7.1 mm lange schroeven

Zes 2.6 mm lange schroeven

[title] Remove the screws securing the lower case
-[* icon_note] Before starting this procedure, you must disable your Mac's ***Auto Boot*** feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. [guide|110034|Use this guide|new_window=true] or follow the abbreviated instructions below to disable Auto Boot.
+[* icon_note] Before starting this procedure, you should disable your Mac's ***Auto Boot*** feature. Auto Boot powers on your Mac when you open the lid, and may be accidentally triggered during disassembly. [guide|110034|Use this guide|new_window=true] to disable Auto Boot.
+ [* black] If your MacBook is running Big Sur v11.1 or later, disabling Auto Boot may not work. You can proceed normally, but make sure to disconnect the battery as soon as you're inside.
[* icon_caution] Completely power off and unplug your MacBook Air before you start. Close the display and flip the entire laptop upside-down.
[* black] Use a P5 driver to remove the following screws:
[* red] Two 7.9 mm screws
[* orange] Two 7.1 mm screws
[* yellow] Six 2.6 mm screws

Your contributions are licensed under the open source Creative Commons license.