Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
German

Translating step 42

Step 42
The logic board assembly is a tight fit, but you can make it easier to remove by inserting a spudger under the left edge and levering it up slightly. There should be no resistance as you remove the logic board. Check all cables carefully and hold them out of the way if needed so they don't snag on the board.
  • The logic board assembly is a tight fit, but you can make it easier to remove by inserting a spudger under the left edge and levering it up slightly.

  • There should be no resistance as you remove the logic board. Check all cables carefully and hold them out of the way if needed so they don't snag on the board.

Die Logic Board-Einheit sitzt sehr eng, aber du kannst dir den Ausbau etwas erleichtern, indem du einen Spudger unter die linke Kante schiebst und sie ganz leicht nach oben hebst.

Das Logic Board sollte sich ohne großen Widerstand entfernen lassen. Überprüfe alle Kabel sorgfältig und schiebe sie, falls nötig, aus dem Weg, so dass sie nicht am Board hängen bleiben.

Your contributions are licensed under the open source Creative Commons license.