Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Dutch

Translating step 12

Step 12
Use a T3 Torx driver to remove the two 1.9 mm screws securing the bracket for the Touch Bar display cable connector. Remove the bracket.
Disconnect the Touch Bar display connector
  • Use a T3 Torx driver to remove the two 1.9 mm screws securing the bracket for the Touch Bar display cable connector.

  • Remove the bracket.

Verwijder, met behulp van een T3 Torx-schroevendraaier, de twee 1.9 mm lange schroeven die de beugel op de kabelaansluiting van het Touch Bar-scherm bevestigen.

Verwijder de beugel.

Your contributions are licensed under the open source Creative Commons license.