Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
German

Translating step 12

Step 12
Use a T3 Torx driver to remove the two 1.9 mm screws securing the bracket for the Touch Bar display cable connector. Remove the bracket.
Disconnect the Touch Bar display connector
  • Use a T3 Torx driver to remove the two 1.9 mm screws securing the bracket for the Touch Bar display cable connector.

  • Remove the bracket.

Entferne die beiden 1,9 mm Torx T3 Schrauben, mit denen die Halterung am Stecker des Touch Bar Displaykabels befestigt ist.

Entferne die Halterung.

Your contributions are licensed under the open source Creative Commons license.