Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 16 guides that include this step.

English
German

Translating step 1

Step 1
Remove the following screws securing the heat sink to the logic board assembly:
  • Remove the following screws securing the heat sink to the logic board assembly:

  • One 2.4 mm Phillips #00 screw

  • One 3.4 mm T5 Torx screw

  • Four 2.7 mm T5 Torx screws

Entferne folgende Schrauben, welche den Kühlkörper an der Einheit des Logic Boards befestigen:

Eine 2,4 mm Kreuzschlitzschraube #00

Eine 3,4 mm Torx T5 Schraube

Vier 2,7 mm Torx T5 Schrauben

Your contributions are licensed under the open source Creative Commons license.