Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Dutch

Translating step 7

Step 7
Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly. Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.
  • Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly.

  • Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.

  • These small screws can strip easily, so make sure your P2 pentalobe driver is in good condition before applying pressure.

Verwijder de vier 3.3 mm lange T5 Torx-schroeven die antennekabelmodule aan beide kanten bevestigen.

Verwijder ook de twaalf 1.1 mm lange P2 pentalobe schroeven die aan beide kanten zitten.

De kop van deze kleine schroeven kan makkelijk worden doorgedraaid, dus zorg ervoor dat je P2 pentalobe schroevendraaier nog goed werkt voordat je deze gebruikt in deze reparatie.

Your contributions are licensed under the open source Creative Commons license.