Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
French

Translating step 7

Step 7
Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly. Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.
  • Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly.

  • Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.

  • These small screws can strip easily, so make sure your P2 pentalobe driver is in good condition before applying pressure.

Dévissez les vis Torx T3 de 3,3 mm qui fixent l'ensemble antenne. Il y en a deux de chaque côté.

Retirez également les vis Pentalobe P2 de 1,1 mm. Il y en a six de chaque côté.

Ces petites vis dérapent facilement, vérifiez que votre tournevis Pentalobe P2 est en bon état avant de vous mettre à l'œuvre.

Your contributions are licensed under the open source Creative Commons license.