Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
Spanish

Translating step 7

Step 7
Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly. Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.
  • Remove the four 3.3 mm T5 Torx screws on both sides, which secure the antenna cable assembly.

  • Also remove the twelve 1.1 mm P2 pentalobe screws on both sides.

  • These small screws can strip easily, so make sure your P2 pentalobe driver is in good condition before applying pressure.

Quita los cuatro tornillos Torx T5 de 3.3 mm de ambos lados, que aseguran el ensamblaje del cable de la antena.

También quita los doce tornillos Pentalobe de P2 de 1.1 mm de ambos lados.

Estos pequeños tornillos se pueden pelar fácilmente, así que asegúrate de que el destornillador P2 Pentalobe esté en buenas condiciones antes de aplicar presión.

Your contributions are licensed under the open source Creative Commons license.