Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 8 guides that include this step.

English
Spanish

Translating step 3

Step 3
Use a spudger or a clean fingernail to pry the battery connector up from its socket on the logic board. Try not to damage the black silicone seal surrounding this and other board connections. These seals provide extra protection against water and dust intrusion.
Disconnect the battery
  • Use a spudger or a clean fingernail to pry the battery connector up from its socket on the logic board.

  • Try not to damage the black silicone seal surrounding this and other board connections. These seals provide extra protection against water and dust intrusion.

  • Bend the connector slightly away from the logic board to prevent it from accidentally making contact with the socket and providing power to the phone during your repair.

Usa la punta de un spudger o una uña para hacer palanca en el conector de la batería y levantarlo de su zócalo en la placa lógica.

Trata de no dañar el sello de silicona negra que rodea este y otras conexiones de placa. Estos sellos proporcionan protección adicional contra la entrada de agua y polvo.

Dobla el conector para separarlo de la placa lógica para prevenir que entre accidentalmente en contacto con el zócalo y que proporcione alimentación al teléfono durante la reparación.

Your contributions are licensed under the open source Creative Commons license.