Skip to main content

Fix Your Stuff

Right to Repair

Store

Spanish
English

Xiaomi Redmi Note 7 Pro Motherboard Replacement

Guide Information

= Done = Incomplete
MotherboardPlaca madre
MotherboardPlaca madre
XiaomiReemplazo de la placa madre de Xiaomi Redmi Note 7 Pro Motherboard Replacement Pro
XiaomiReemplazo de la placa madre de Xiaomi Redmi Note 7 Pro Motherboard Replacement Pro
This guide shows how to remove or replace the motherboard in theEsta guía muestra cómo quitar o reemplazar la placa madre en el Xiaomi Redmi Note 7 Pro
This guide shows how to remove or replace the motherboard in theEsta guía muestra cómo quitar o reemplazar la placa madre en el Xiaomi Redmi Note 7 Pro
    This guide shows how to remove or replace the motherboard in theEsta guía muestra cómo quitar o reemplazar la placa base en el Xiaomi Redmi Note 7 Pro. You’ll need '''replacement adhesive''' to reattach components when reassembling the device. Necesitarás un adhesivo de repuesto para volver a colocar los componentes cuando vuelvas a montar el dispositivo.
    This guide shows how to remove or replace the motherboard in theEsta guía muestra cómo quitar o reemplazar la placa base en el Xiaomi Redmi Note 7 Pro. You’ll need '''replacement adhesive''' to reattach components when reassembling the device. Necesitarás un adhesivo de repuesto para volver a colocar los componentes cuando vuelvas a montar el dispositivo.

      Describe the specific part or component of this device you're working on. Ex: Battery

      Create a title.

      This brief summary will only appear in search results.

      Communicate background information before the reader dives into the guide.

      Guide Steps

      Step 1

      Before you begin, switch off your phone.

      Step 2

      Lift the rear cover to create a gap between the glass and the frame.

      Step 3

      Start to slide the opening pick from the bottom left corner along the side of the Xiaomi Redmi Note 7 Pro to cut the adhesive.

      Step 4

      Lift the cover from right to left, but do not do it completely while the flex cable is still connected.

      Step 5

      Using a screwdriver (1.5 mm ), unscrew 1 screw and remove the bracket holding the connector.

      Step 6

      Disconnect the battery connector. Warning! Recommend disconnecting the connector to avoid a possible short circuit during disassembly.

      Step 7

      Using a screwdriver (1.5 mm), unscrew 7 bolts.

      Step 8

      Pry up the connector and remove the fingerprint sensor cable.

      Step 9

      Disconnect the connector on PCB, and remove the front (selfie) camera.

      Step 10

      Disconnect connectors on the PCB.

      Step 11

      Remove the PCB.

      Your contributions are licensed under the open source Creative Commons license.