Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 8 guides that include this step.

English
Spanish

Translating step 9

Step 9
Continue pulling the display down (toward the Lightning port) as needed in order to make a gap large enough for the pick. Slide the pick to the top left corner and cut any remaining adhesive securing the display.
  • Continue pulling the display down (toward the Lightning port) as needed in order to make a gap large enough for the pick.

  • Slide the pick to the top left corner and cut any remaining adhesive securing the display.

  • Again, don't insert the pick more than a few millimeters—about the width of the display bezel—or you may damage the front panel sensor array.

Continúa tirando de la pantalla hacia abajo (hacia el puerto Lightning) según sea necesario para crear una abertura que sea suficientemente grande para la púa.

Desliza la púa de apertura a la esquina superior izquierda y corta cualquier adhesivo restante que sujeta la pantalla.

Nuevamente, no insertes la púa más de unos pocos milímetros (aproximadamente el ancho del bisel de la pantalla), ya que podría dañar la matriz de sensores del panel frontal.

Your contributions are licensed under the open source Creative Commons license.