Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 35 guides that include this step.

English
Dutch

Translating step 1

Step 1
Be very careful to pry evenly on the digitizer connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work. To minimize stress on the socket, try prying under the short edge of the connector, rather than the long edge which is shown in these images.
  • Be very careful to pry evenly on the digitizer connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work.

  • To minimize stress on the socket, try prying under the short edge of the connector, rather than the long edge which is shown in these images.

  • Gently pry the digitizer connector up from its socket on the logic board.

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.