Skip to main content

Fix Your Stuff

Right to Repair

Parts & Tools

Notice: You are editing a prerequisite guide. Any changes you make will affect all 42 guides that include this step.

English
German

Translating step 11

Step 11
Starting at the top right of the device, slide the spudger in between the LCD frame and metal backing plate, which will separate the adhesive as you push. The goal is to separate the adhesive, not to pry the LCD up, so keep the pointed tip of the spudger as low as possible to prevent bending the LCD. If inserting the spudger causes the corner of the LCD to bend up, repeat the steps with the guitar pick to further loosen the adhesive.
  • Starting at the top right of the device, slide the spudger in between the LCD frame and metal backing plate, which will separate the adhesive as you push.

  • The goal is to separate the adhesive, not to pry the LCD up, so keep the pointed tip of the spudger as low as possible to prevent bending the LCD.

  • If inserting the spudger causes the corner of the LCD to bend up, repeat the steps with the guitar pick to further loosen the adhesive.

Fange rechts oben am Gerät an, schiebe den Spudger zwischen LCD Rahmen und Metallplatte, dabei wird sich die Klebeverbindung lösen.

Das Ziel ist das Lösen der Verbindung, nicht das LCD hochzuhebeln. Halte deswegen die Spudgerspitze so flach wie möglich, um das LCD nicht zu verbiegen.

Wenn sich beim Einführen des Spudgers die Ecke des LCD nach oben verbiegt, musst du die Schritte mit dem Gitarrenplektrum noch ein Mal wiederholen, um die Klebeverbindung weiter zu trennen.

Your contributions are licensed under the open source Creative Commons license.