Skip to main content
English
German

Translating step 24

Step 24
Slide the long edge of a plastic card about 0.5 inches (13 mm) under the center of the mid-battery circuit board to cut through the remaining adhesive. Slide the long edge of a plastic card about 0.5 inches (13 mm) under the center of the mid-battery circuit board to cut through the remaining adhesive.
  • Slide the long edge of a plastic card about 0.5 inches (13 mm) under the center of the mid-battery circuit board to cut through the remaining adhesive.

Schiebe die lange Seite einer Plastikkarte etwa 13 mm tief unter die Mitte der Leiterplatte der mittleren Akkuzelle und trenne den restlichen Kleber auf.

Your contributions are licensed under the open source Creative Commons license.