Skip to main content
English
German

Translating step 12

Step 12
Tilt the bottom of the iPad up. Apply a few drops of adhesive remover evenly along the elevated edge of the battery. A little bit goes a long way, so start with a very small amount. You can always add more later if needed. Applying the solvent in small amounts helps prevent unwanted leaks.
Apply adhesive remover to the bottom of the battery
  • Tilt the bottom of the iPad up.

  • Apply a few drops of adhesive remover evenly along the elevated edge of the battery.

  • A little bit goes a long way, so start with a very small amount. You can always add more later if needed. Applying the solvent in small amounts helps prevent unwanted leaks.

Kippe die Unterseite des iPads nach oben.

Träufle etwas Klebstoffentferner gleichmäßig an der erhöhten Akkukante entlang.

Du brauchst nur eine kleine Menge, beginne also mit wenigen Tropfen. Du kannst später immer noch mehr hinzufügen, wenn nötig. Wenn du nur kleine Mengen des Lösungsmittels zugibst, vermeidest du ein ungewolltes Auslaufen.

Your contributions are licensed under the open source Creative Commons license.