Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 21 guides that include this step.

English
Japanese

Translating step 13

Step 13
Slowly lift the display from its top edge, being careful not to strain the attached ribbon cables. Remove the two 1.3 mm Phillips screws securing the display connector cover bracket. You may need to angle the driver slightly in order to avoid straining the ribbon cables.
  • Slowly lift the display from its top edge, being careful not to strain the attached ribbon cables.

  • Remove the two 1.3 mm Phillips screws securing the display connector cover bracket.

  • You may need to angle the driver slightly in order to avoid straining the ribbon cables.

  • Remove the display connector cover bracket.

上部端からディスプレイをゆっくりと持ち上げます。リボンケーブルを引っ張らないようにご注意ください。

ディスプレイコネクタカバーのブラケットを固定している1.3mmプラスネジを2本外します。

リボンケーブルを引っ張らないようにドライバーに若干斜めにしてください。

ディスプレイコネクタのカバーブラケットを外します。

Your contributions are licensed under the open source Creative Commons license.