Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 20 guides that include this step.

English
Chinese

Translating step 4

Step 4
Hold the iPod firmly against a table or bench. Place your thumb and index finger over the lower corners of the display to stop the display from opening too far when the adhesive breaks. Lift the suction cup up and back toward the top of the iPod. Be patient, and pull with firm, constant force until the adhesive breaks and the display comes up from the rear case.
  • Hold the iPod firmly against a table or bench.

  • Place your thumb and index finger over the lower corners of the display to stop the display from opening too far when the adhesive breaks.

  • Lift the suction cup up and back toward the top of the iPod. Be patient, and pull with firm, constant force until the adhesive breaks and the display comes up from the rear case.

  • It may be necessary to use a heat gun to soften the adhesive (especially in cooler climates). If you can pry the screen apart, and the adhesive is still sticking and pulling apart like cheese topping on a pizza, you can slide a thin razor blade in and gently cut the adhesive.

  • After the display begins to lift from the rear case, be careful not to lift more than about an inch—a fragile plastic frame still connects the display assembly to the rear case.

紧紧抓住桌面上的iPod。

将拇指和食指放在显示屏的下角,以防止粘合剂断裂时显示屏打开得太远。

将吸盘向上提起,朝向iPod的顶部。 耐心等待,并用力拉紧,直到粘合剂破裂,显示器从后壳上出来。

可能需要使用热风枪来软化粘合剂(特别是在较冷的气候条件下)。 如果您可以将屏幕分开,但粘合剂仍然粘在一起,像披萨上的奶酪一样,您可以用剃刀刀片轻轻地切割粘合剂。

显示器从后壳开始抬起之后,请小心不要抬起超过一英寸 - 一个易碎的塑料框架仍将显示屏组件连接到后壳。

Your contributions are licensed under the open source Creative Commons license.