Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 9 guides that include this step.

English
Chinese

Translating step 6

Step 6
Remove the five screws securing the logic board connector bracket to the rear case: One 1.3 mm Phillips #000 screw
Unscrew the logic board connector cover
  • Remove the five screws securing the logic board connector bracket to the rear case:

  • One 1.3 mm Phillips #000 screw

  • One 1.5 mm Phillips #000 screw

  • Three 1.2 mm Y000 screws

  • Remove the bracket.

  • Be careful not to lose the smaller bracket clipped onto the edge. It's secured with a small clip and is easy to accidentally knock off of the larger bracket.

拧下将逻辑板连接器支架固定至后壳的五颗螺钉:

一颗 1.3 mm Phillips #000 螺丝

一颗1.5 mm Phillips #000 螺丝

一颗 1.2 mm Y000 螺丝

拿下盖板

注意不要丢失夹在边缘上的小支架 。 它用小夹子固定,很容易会从较大的支架上意外脱落下来。

Your contributions are licensed under the open source Creative Commons license.