Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.

English
Japanese

Translating step 2

Step 2
Pull the camera cable parallel to the face of the I/O board toward the hinge of the Air to disconnect it from its socket, using the tip of a spudger to help push the connector out of its socket.
  • Pull the camera cable parallel to the face of the I/O board toward the hinge of the Air to disconnect it from its socket, using the tip of a spudger to help push the connector out of its socket.

  • Do not lift upward on this cable as you disconnect it, as its socket may break off the logic board.

I / Oボード表面と平行にカメラケーブルをAirのヒンジ側に向けて引き抜いてソケットから切り離します。スパッジャーの先端を使って、コネクタをソケットから押し出します。

このケーブルを外すときに、ケーブルを上向きに持ち上げないでください。ソケットがロジックボードを破損する可能性があります。

Your contributions are licensed under the open source Creative Commons license.