Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

English
German

Translating step 2

Step 2
Use the flat end of a spudger to loosen the adhesive underneath the digitizer ribbon cable. Very carefully pull the digitizer ribbon cable straight out of its sockets on the logic board.
  • Use the flat end of a spudger to loosen the adhesive underneath the digitizer ribbon cable.

  • Very carefully pull the digitizer ribbon cable straight out of its sockets on the logic board.

Löse den Kleber unter dem Digitizer Flachbandkabel mit dem flachen Ende eines Spudgers.

Ziehe vorsichtig das Digitizer Flachbandkabel gerade aus seiner Fassung auf dem Logic Board heraus.

Your contributions are licensed under the open source Creative Commons license.