Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 5 guides that include this step.

English
Spanish

Translating step 1

Step 1
Remove the two screws securing the Taptic Engine:
Remove the Taptic Engine
  • Remove the two screws securing the Taptic Engine:

  • One 2.1 mm Phillips screw

  • One 2.1 mm standoff screw

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

Remueve los dos tornillos que sujetan el motor táptico:

Un tornillo Phillips de 2.1mm

Un tornillo separador de 2.1 mm

Los tornillos separadores son mejor removidos usando un destornillador de tornillos separadores o punta.

Si no hay otro remedio, un pequeño destornillador de cabeza plana hará el trabajo—pero ten precaución extra para asegurarte de que no se resbale y dañe los componentes que lo rodean.

Your contributions are licensed under the open source Creative Commons license.