Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

English
Chinese

Translating step 6

Step 6
Remove the battery from the iPhone.
Remove the battery
  • Remove the battery from the iPhone.

  • If your replacement battery came in a plastic sleeve, slide off and remove the sleeve before installation.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

  • If your new battery doesn’t have adhesive preinstalled, refer to this guide to replace the adhesive strips.

  • Perform a force restart after reassembly. This can prevent several issues and simplify troubleshooting.

  • Before you adhere the replacement battery, temporarily reconnect the battery connector to the logic board socket. This ensures that the battery is properly aligned in its recess.

  • Adhere the battery, disconnect it, and continue reassembling your device.

从 iPhone 中取出电池

如果你的新电池套了包装袋,请在安装前移除包装。

如果你的手机内仍然有酒精残留在内,那么安装新电池前小心的把它擦拭干,或者允许它自然风干。

如果你的新电池没有预置电池胶,安装电池时,请参阅这个指南更换电池的胶条。

重新安装后执行强制重启。 这可以防止多个问题并简化故障排除。

在你将新电池粘贴到 iPhone 上之前,暂时把它连接到主板上一会。这能够保证你的电池安装位置完全正确。

把电池粘贴到 iPhone 上,断开连接,然后继续安装你的设备。

Your contributions are licensed under the open source Creative Commons license.