Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 14 guides that include this step.

English
German

Translating step 6

Step 6
Slide the pick along the edge of the display, towards the headphone jack. If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat. Don't insert the pick past the bezel into the display area, or you will damage it.
  • Slide the pick along the edge of the display, towards the headphone jack.

  • If there is still a considerable amount of resistance when sliding the opening pick, repeat the iOpener heating procedure and apply additional heat.

  • Don't insert the pick past the bezel into the display area, or you will damage it.

  • A good rule of thumb is to never insert the opening pick more than a quarter inch into the iPad.

Schiebe das Plektrum in Richtung Kopfhörerbuchse an der Kante des Displays entlang.

Wenn das Auftrennen schwergängig wird, dann erhitze den iOpener erneut und lege ihn wieder auf.

Schiebe das Plektrum nicht weiter als die Blende in das Display hinein, es könnte sonst beschädigt werden.

Als gute Faustregel gilt, dass das Plektrum nicht tiefer als 7 mm in das iPad eingeschoben werden darf.

Your contributions are licensed under the open source Creative Commons license.