Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 14 guides that include this step.

English
German

Translating step 5

Step 5
Firmly pull up on the suction cup to create a small gap between the front panel and the rear case. Do not pull too hard or you may shatter the glass. Once you've opened a sufficient gap, insert an opening pick into the gap to prevent the adhesive from resealing.
  • Firmly pull up on the suction cup to create a small gap between the front panel and the rear case.

  • Do not pull too hard or you may shatter the glass.

  • Once you've opened a sufficient gap, insert an opening pick into the gap to prevent the adhesive from resealing.

Ziehe fest am Saugheber, bis sich zwischen dem Rückgehäuse und dem Frontpanel ein Spalt bildet.

Ziehe aber auch nicht zu fest, da das Glas sonst zerbrechen kann.

Wenn der Spalt groß genug ist, dann setze ein Plektrum in den Spalt ein, so dass der Kleber sich nicht wieder verbinden kann.

Your contributions are licensed under the open source Creative Commons license.