Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 5 guides that include this step.

English
Chinese

Translating step 7

Step 7
To reinstall the back cover with a custom-cut adhesive strip, follow this guide. If you're cleaning the midframe surface with isopropyl alcohol, be careful not to get any alcohol on the wireless charging coil. The coil coating will break down if it contacts alcohol.
  • To reinstall the back cover with a custom-cut adhesive strip, follow this guide.

  • If you're cleaning the midframe surface with isopropyl alcohol, be careful not to get any alcohol on the wireless charging coil. The coil coating will break down if it contacts alcohol.

  • Be sure to turn on your phone and test your repair before installing new adhesive and resealing the phone.

  • If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.

如果需要使用客制化胶带重新安装后盖,请参考本教程

如果要用异丙醇清洁中框表面,请注意不要在无线充电线圈上沾上任何酒精。如果线圈涂层接触酒精,则会破裂。

在使用新的胶带重新密封手机之前,请确认你已启动手机,测试了相关的维修项目。

如果你愿意,你也可以在不更换胶带的前提下重新安装后盖。除去所有可能影响后盖平整放置的大块胶带。安装后盖之后,加热后盖并施加压力以保证固定。这么做不会让你的手机防水,但是通常情况下,胶带已经足够坚固。

Your contributions are licensed under the open source Creative Commons license.