Skip to main content

Fix Your Stuff

Right to Repair

Store

Notice: You are editing a prerequisite guide. Any changes you make will affect all 22 guides that include this step.

English
Japanese

Translating step 15

Step 15
Make sure the battery is disconnected before you disconnect or reconnect the cables in this step. Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables: Front-facing camera and sensor cable
Disconnecting the front panel assembly cables
  • Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.

  • Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables:

  • Front-facing camera and sensor cable

  • LCD cable

  • Digitizer cable

  • When reassembling your phone, the LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery.

フラスチックの開口ツールを使って次の3つのフロントパネルアセンブリケーブルを外します。

正面カメラとセンサーケーブル

LCDケーブル

デジタイザーケーブル

デバイスを再組み立てする際、LCDケーブルがコネクターから外れることがあります。これは電話の電源を入れた時、画面にホワイトラインや何も表示されない原因となります。もしこの状態が発生したら、単純にケーブルを再接続し、電源を再起動させてください。電源を再起動する方法については、バッテリーの再接続をご覧ください。

[*title] Disconnecting the front panel assembly cables
[* icon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
[*
black] Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables:
[*title] Disconnecting the front panel assembly cables
[* icon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
[*
black] Use a plastic opening tool or a fingernail to disconnect the three front panel assembly cables:
[* red] Front-facing camera and sensor cable
[* orange] LCD cable
[* yellow] Digitizer cable
[* icon_caution] When reassembling your phone, the LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to [guide|10587|disconnect and reconnect the battery|stepid=38507battery|stepid=133257].
[* icon_caution] When reassembling your phone, the LCD cable may pop off the connector. This can cause white lines, or nothing at all to appear when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to [guide|10587|disconnect and reconnect the battery|stepid=38507battery|stepid=133257].

Your contributions are licensed under the open source Creative Commons license.