Skip to main content
English
Spanish

Translating step 9

Step 9
Remove 3 silver 12mm Philips #2 screws joining the DMD optical section to the front lens.  The three screws cannot be seen in one picture, so three pictures are attached. The top screw is visible as you look down on the unit. The left hand screw is seen as you look along the left hand underside of the DMD heat sink
Separate the front lens section
  • Remove 3 silver 12mm Philips #2 screws joining the DMD optical section to the front lens. The three screws cannot be seen in one picture, so three pictures are attached.

  • The top screw is visible as you look down on the unit.

  • The left hand screw is seen as you look along the left hand underside of the DMD heat sink

  • The right hand screw is visible as you look along the right hand underside of the DMD heat sink.

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.