Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 22 guides that include this step.

English
Japanese

Translating step 1

Step 1
Use the point of a spudger to pry the lower display connector out of its socket. To re-attach press connectors like this one, press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
Disconnect the display and digitizer
  • Use the point of a spudger to pry the lower display connector out of its socket.

  • To re-attach press connectors like this one, press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.

スパッジャーの先端を使用して、ディスプレイ下側にあるコネクタをソケットから外します。

このようなプレスコネクターを再装着するには、片方の端がカチッと音がするまで押し、次に反対側も同様に押します。 中央部分は押さないでください。 コネクタの位置がちょっとでもずれていると、コネクタが曲がってしまい、永久的な損傷を引き起こす可能性があります。

Your contributions are licensed under the open source Creative Commons license.