Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

English
German

Translating step 2

Step 2
Undo the single screw attaching the cleaning station to the carriage support. If you have not already done so, put on your gloves now. The cleaning station is full of ink, and you can't handle it without getting ink on you.
Remove the Cleaning Station.
  • Undo the single screw attaching the cleaning station to the carriage support.

  • If you have not already done so, put on your gloves now. The cleaning station is full of ink, and you can't handle it without getting ink on you.

  • Release the air lines from the clips in the cleaning station.

  • Detach the smaller hose from the T joint.

  • Pull up on the carriage support. This should give you enough room to work the cleaning station out of the printer.

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.