Skip to main content

Notice: You are editing a prerequisite guide. Any changes you make will affect all 16 guides that include this step.


Translating step 3

Step 3
No image
  • This is a diagram of the ribbon clamp connectors you will disconnect in the next step.

  • 1) With your fingernails, grasp the locking bar on either side and pull up a small amount (about 1/16" or 2 mm).

  • 2) After disengaging the locking bar, slide the cable out of the connector.

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.