Introduction
After two years of use the whisk of our milk frother turned only slowly. It could be stopped with one finger. I found an instruction that suggested to change the polarity of the motor by exchanging the connection cables. This worked with our two milk frothers.
What you need
-
-
Remove the three screws with a screwdriver PH2
-
There is a little triangle impressed in the bottom plate to show the position of the on-switch.
-
-
-
-
On one side of the plug you see two slots. You can see the cable shoes in there.
-
With something pointed (eg. watchmaker's screwdriver) you press in one slot to open the cable shoe's locking catch. At the same time you pull on the cable.
-
Do the same with the second cable.
-
Exchange the position of the cables and push the cable shoes back in the plug.
-
Cancel: I did not complete this guide.
One other person completed this guide.
Special thanks to these translators:
100%
John Maier is helping us fix the world! Want to contribute?
Start translating ›
One Comment
Bei unserem bauähnlichen Milchschäumer Petra ließ sich das gleiche Problem genauso beheben.