Skip to main content

Fix Your Stuff

Right to Repair

Store

Help

Time Estimate

Select a difficulty level for this entire task (including any prerequisite instructions). The difficulty ranking reflects the experience, physical dexterity, and risk involved.

Very easy

Does not require opening device.

Easy

Requires minimal disassembly and requires only basic tools like a Phillips or flat-head screwdriver.

Moderate

Requires a fair amount of disassembly. This is a task that most people would not perform without instruction.

Difficult

Requires significant disassembly and may require specialized tasks like soldering.

Very difficult

This task is considered quite challenging, may require specialized tasks like micro-soldering, and may risk damage to the device. If you can do this, people may call you MacGyver on occasion.

If your guide picks up where an existing guide leaves off, add the existing guide as a prerequisite to avoid having to write additional steps. Prerequisite guides will be displayed before this guide. Make sure that the prerequisite guides are in the correct order. You can change the prerequisite order by dragging the icons to the left of the guide's name.

  • 1 × phillips screwdriver, general
  • 10 × machine washers
  • 1 × 3D printed universal drawer track spacerThe spacer is designed for use on either side. pick your required width: 1mm-6mm. One spacer can be used on either side for better drawer alignment and up to 12mm of gap adjustment
  • 1 × Flat head wood screwThe original drawer screw may not be long enough after the drawer track spacer is added. Use a longer equivalent size screw to account for the spacer if needed
Add New

Your contributions are licensed under the open source Creative Commons license.