To remove the debris extractor, first begin by removing and emptying the trash bin. Push down and pull out on the silver button located on the top of the Roomba in the back.
  • To remove the debris extractor, first begin by removing and emptying the trash bin.

  • Push down and pull out on the silver button located on the top of the Roomba in the back.

  • The trash bin should then slide out.

Add Comment

With the Roomba upside down, locate the two yellow buttons by the extractor. To open the flap holding the extractos in place, pinch the two yellow buttons together towards the center and pull up on the flap at the same time
  • With the Roomba upside down, locate the two yellow buttons by the extractor.

  • To open the flap holding the extractos in place, pinch the two yellow buttons together towards the center and pull up on the flap at the same time

Add Comment

Once the flap is open, grab the yellow end of the dark gray extractor and pull up slightly. After lifting it up about an inch, pull it out towards one of the side wheels. The extractor should slide out with ease. Repeat the same procedure for the light gray debris extractor.
  • Once the flap is open, grab the yellow end of the dark gray extractor and pull up slightly.

  • After lifting it up about an inch, pull it out towards one of the side wheels.

  • The extractor should slide out with ease. Repeat the same procedure for the light gray debris extractor.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Ryan Murphy

Member since: 03/02/2017

431 Reputation

4 Guides authored

Team

USF Tampa, Team S13-G5, Cagle Spring 2017 Member of USF Tampa, Team S13-G5, Cagle Spring 2017

USFT-CAGLE-S17S13G5

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 7

Past 30 Days: 23

All Time: 106