Introduction

This guide is useful for replacing a dead battery or a battery that cannot be recharged through the dock for some reason. This guide is pretty simple can be done in 3 steps, and won't break anything important

  1. Flip the Roomba upside down. Using the Phillips #0 screwdriver, carefully remove the 5 mm screw holding the brush in place.
    • Flip the Roomba upside down. Using the Phillips #0 screwdriver, carefully remove the 5 mm screw holding the brush in place.

  2. Gently pull the brush up and remove it from the device.
    • Gently pull the brush up and remove it from the device.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  4. Unscrew the four 10mm screws on the underside of the Roomba using a Phillips #1 screwdriver.
    • Unscrew the four 10mm screws on the underside of the Roomba using a Phillips #1 screwdriver.

  5. Remove the bottom frame of the device.
    • Remove the bottom frame of the device.

  6. Grab the green tape attached to the end of the battery and remove the battery from the device.
    • Grab the green tape attached to the end of the battery and remove the battery from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Adrian Martinez Arbolaez

Member since: 10/02/2017

128 Reputation

1 Guide authored

Team

USF Tampa, Team S10-G5, Thompson Fall 2017 Member of USF Tampa, Team S10-G5, Thompson Fall 2017

USFT-THOMPSON-F17S10G5

3 Members

5 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 13

Past 30 Days: 38

All Time: 561