Introduction

This is an easy guide. It should only take a few minutes to complete. The only tool required is Phillips #1 Screwdriver.

Parts

No parts required.

  1. Lay the Roomba upside down on a flat surface.
    • Lay the Roomba upside down on a flat surface.

    • The edge brush is located near the battery pack.

    Add Comment

  2. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

  3. Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.
    • Using the Phillips #1 Screwdriver, unscrew the 7.2 mm Phillips #1 screw while holding the edge brush in place.

    Add Comment

    • Grab the edge brush and lift it up to remove.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Samantha Barrett

Member since: 01/13/2014

501 Reputation

5 Guides authored

Team

Cal Poly, Team 17-5, Forte Winter 2014 Member of Cal Poly, Team 17-5, Forte Winter 2014

CPSU-FORTE-W14S17G5

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 323