iPhone 7 Speaker Assembly Replacement

Step 1 Speaker Assembly

• Remove the Phillips screw securing the Wi-Fi diversity antenna to the rear case:
• One 3.2 mm screw
Step 2

• Remove the following three Phillips screws securing the speaker to the rear case:
• Two 1.3 mm screws
• One 2.0 mm screw
Step 3
• Use the point of a spudger to lift the two antenna cable connectors up off of the sockets on the logic board.
Step 4
• Use tweezers to derout the antenna cables from their bracket on the logic board.
Step 5
• Use tweezers to remove the antenna cables from the clip on the speaker.
• Make sure to grasp the cable near the clip in order to avoid damaging the cable.
Step 6
• Use the tip of a spudger to slide the speaker assembly towards the logic board and off of the rear case.
Step 7
• Remove the speaker.

Author

with 3 other contributors

Scott Havard

Member since: 06/27/16

49,630 Reputation

31 Guides authored

Badges: 38

• 
• 
• 

+35 more badges

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview