Skip to main content

iPhone 4S Battery Replacement

What you need

  1. iPhone 4S Battery Replacement, Pentalobe Screws: step 1, image 1 of 1
    • Remove the Bottom Pentalobe Screws next to the charger connecter.

    • It is recommended that you use a small 5-Point screwdriver.

    • Remember to make sure your iPhone is fully turned off before tearing it down, to prevent serious injury.

  2. iPhone 4S Battery Replacement, Back Panel Removal: step 2, image 1 of 2 iPhone 4S Battery Replacement, Back Panel Removal: step 2, image 2 of 2
    • Push the back panel towards the top edges of the iPhone. Doing this should allow the back to slide off.

    • Do NOT apply so much pressure. Especially if your iPhone is cracked.

    • Do not rush it! Time is key.

  3. iPhone 4S Battery Replacement, Battery Screws: step 3, image 1 of 1
    • Remove these two screws that are securing the battery connecter to the Logic Board.

    • Remember to focus and pay attention. So you don't accidentally slip and pierce the Battery!

    • For the bottom screw, it is recommended that you use a 1.5 mm Screwdriver, and a 1.7 mm for the top screw.

  4. iPhone 4S Battery Replacement, Battery Strip: step 4, image 1 of 1
    • Locate and pull the Plastic tab to pull out battery. Make sure to pry up outsides of battery on other sides as well.

    • Do not pull the plastic tab to hard, as it can easily rip!

  5. iPhone 4S Battery Replacement, Battery Removal: step 5, image 1 of 1
    • Carefully remove the battery.

    • Remember, if you are replacing your battery, remember to preform a hard reset on your iPhone once its all finished.

Conclusion

To reassemble your device, follow these instructions in reverse order.

58 other people completed this guide.

Cole Anello

Member since: 11/01/16

1,944 Reputation

1 Guide authored

One Comment

la olum bunu benim 1 yaşında kızım da biliyo

ahmetceylanbm - Reply

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 25

Past 30 Days: 106

All Time: 20,517