Skip to main content

Introduction

Removing LCD assembly with front panel attached. Internal Prerequisite.

  1. Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.
    • Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.

  2. Lift the LCD from its long edge closest to the volume buttons and rotate it out of the rear case. Lay the LCD on the front panel as seen in the second picture.
    • Lift the LCD from its long edge closest to the volume buttons and rotate it out of the rear case.

    • Lay the LCD on the front panel as seen in the second picture.

  3. MacBook Battery Fix Kits

    Starting at $69.99

    Buy Now

    MacBook Battery Fix Kits

    Starting at $69.99

    Buy Now
  4. Use the edge of a plastic opening tool to flip up the metal retaining clip securing the display data cable to its socket on the logic board.
    • Use the edge of a plastic opening tool to flip up the metal retaining clip securing the display data cable to its socket on the logic board.

  5. Pull the display data cable out of its socket on the logic board.
    • Pull the display data cable out of its socket on the logic board.

    • Do not lift upward on the display data cable connector as you disconnect it.

  6. Remove the LCD assembly from the iPad 2.
    • Remove the LCD assembly from the iPad 2.

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 307