Introduction

Use this guide to remove your access door.

Parts

No parts required.

  1. Unplug your iMac's AC cord along with any peripheral devices.
    • Unplug your iMac's AC cord along with any peripheral devices.

    • Lay your iMac face-down on a soft, clean surface as shown.

    • Be sure there isn't any dirt or debris on your work surface, as it may scratch the glass panel on the front of your iMac. We recommend placing a towel between the iMac and the work surface.

    • Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.

    • All three screws will remain captive in the access door.

    • Remove the access door.

    Before beginning unplug your iMac.

    Henry Barnett - Reply

    The screws are not phillips #1 as implied above. My phillips#2 bit fit.

    John McWilliams - Reply

    Yes phillips #2 is the correct Bit

    Heath - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

5 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 22

All Time: 4,100