Introduction

Remove the access door to replace RAM chips.

Parts

No parts required.

Loosen the three Phillips screws securing the access door to the bottom edge of your iMac. These screws will remain captive in the access door.
  • Loosen the three Phillips screws securing the access door to the bottom edge of your iMac.

  • These screws will remain captive in the access door.

  • Remove the access door from your iMac.

  • During reassembly, fasten the access door loosely and align it with the pocket cut into the outer case of the iMac before fully tightening the screws.

In order for the logic board to come out cleanly, one should remove the RAM at the end of this step.

kevmacmills - Reply

Definitely! The author should make this as a step in the description (because not everyone reads Comments)

finnik2d - Reply

Just did this procedure and the RAM must absolutely come out for the logic board to come free later.

matt - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 8

Past 30 Days: 44

All Time: 7,482