Introduction

This will show you how to install a new speaker into your iHome. For help troubleshooting click the link to our troubleshooting page iHome IH11 Troubleshooting.

Image 1/1: Remove the translucent bottom case.
  • Unscrew the two 9.0 mm screws with a Phillips #1 screwdriver.

  • Remove the translucent bottom case.

Add Comment

Image 1/2: Repeat the previous step for the two 9.0mm screws on the bottom. Image 2/2: Carefully slide the back cover off. There are wires connected to the back cover.
  • Remove the two 9.0mm screws on the back of the iHome with a Phillips #1 screwdriver.

  • Repeat the previous step for the two 9.0mm screws on the bottom.

  • Carefully slide the back cover off. There are wires connected to the back cover.

Add Comment

Image 1/1:
  • Remove the two 12.0mm screws holding the speaker to the iHome with a Phillips #1 screwdriver.

Add Comment

Image 1/2: Carefully lift speaker out of its casing. Image 2/2: Carefully lift speaker out of its casing.
  • Remove the four 12.0mm screws on the face of the speaker with the Phillips #1 Screwdriver.

  • Carefully lift speaker out of its casing.

Add Comment

Image 1/1:
  • Unsolder the two wires that connect to the speaker.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Courtney Steinberg

Member since: 04/19/2013

23 Reputation

3 Guides authored

Team

Cal Poly, Team 14-9, Maness Spring 2013 Member of Cal Poly, Team 14-9, Maness Spring 2013

CPSU-MANESS-S13S14G9

5 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 253