Introduction

Replace the dock connector on your iHome iP11, so you can play music and charge your battery once again. For help troubleshooting click the link to our troubleshooting page iHome IH11 Troubleshooting.

  1. Remove the two 9mm screws that hold on the dock connector with a Phillips #1 Screwdriver.
    • Remove the two 9mm screws that hold on the dock connector with a Phillips #1 Screwdriver.

    Add Comment

  2. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
  3. Pop the dock connector out of the iHome and gently pull the white plastic plug connected to the dock connector apart.
    • Pop the dock connector out of the iHome and gently pull the white plastic plug connected to the dock connector apart.

    • Remove the four 7.0mm screws with a Phillips #1 screwdriver.

    Add Comment

    • Remove both of the black plastic pieces. They should easily slide off of the two guide holes in the circuit board.

    • The dock connector should now be exposed. You can now simply put your new dock connector in the old one's place.

    Where can. I find the. Pin out. For this. Connector

    Roy H - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Nick Knowles

Member since: 04/19/2013

18 Reputation

2 Guides authored

Team

Cal Poly, Team 14-9, Maness Spring 2013 Member of Cal Poly, Team 14-9, Maness Spring 2013

CPSU-MANESS-S13S14G9

5 Members

5 Guides authored

2 Comments

Where can I buy a replacement dock connector?

A Ross - Reply

Likewise, this guide isn't much good if it uses parts that are unavailable.

CJ Shumate - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 2,198