Image 1/1: Starting from the portholes, use plastic opening tool to pry in between the front panel and back cover.  Follow the opening along the corners and sides until all latches are unclipped.
  • Place a tablet on a table facing front.

  • Starting from the portholes, use plastic opening tool to pry in between the front panel and back cover. Follow the opening along the corners and sides until all latches are unclipped.

  • Remove back cover completely and place it outside of the work area.

Add Comment

Image 1/2: Use Philips screw driver to unscrew each one, and carefully place screws in a safe place. Image 2/2: Use Philips screw driver to unscrew each one, and carefully place screws in a safe place.
  • With the tablet faced down, locate the 4mm screws along the perimeter of the motherboard; there should be 4 screws.

  • Use Philips screw driver to unscrew each one, and carefully place screws in a safe place.

Add Comment

Image 1/3: Safely remove mother board and battery from tablet by using tweezers. Image 2/3: Make sure the small ribbon wires are not damaged when removing larger members. Image 3/3: Make sure the small ribbon wires are not damaged when removing larger members.
  • After screws are removed, gently pull up on the ribbon wire connection to release all 3 wires from the motherboard.

  • Safely remove mother board and battery from tablet by using tweezers.

  • Make sure the small ribbon wires are not damaged when removing larger members.

Add Comment

Image 1/1: Be careful not to touch the wire/battery connection correctly, as it could result in injury.
  • Remove tape from battery pack, and dispose.

  • Be careful not to touch the wire/battery connection correctly, as it could result in injury.

Add Comment

Image 1/3: Use small Philips screw driver to unscrew all 6 of the 2mm. screws. Image 2/3: Use fingers and prying tool to remove the touch sensor unit from frame. Image 3/3: Use fingers and prying tool to remove the touch sensor unit from frame.
  • After removing the battery pack and motherboard, the touch sensor unit should be visible.

  • Use small Philips screw driver to unscrew all 6 of the 2mm. screws.

  • Use fingers and prying tool to remove the touch sensor unit from frame.

Add Comment

Image 1/3: Insert new touch sensor plate into the same position, aligning all screw inputs. Image 2/3: Insert all six of the 2mm. screws to connect the new touch sensor to the screen frame. Image 3/3: Insert all six of the 2mm. screws to connect the new touch sensor to the screen frame.
  • After the touch sensor is detached, only the plastic screen should remain.

  • Insert new touch sensor plate into the same position, aligning all screw inputs.

  • Insert all six of the 2mm. screws to connect the new touch sensor to the screen frame.

Add Comment

Image 1/1: Be careful when reconnecting battery, use safety goggles and gloves.
  • To continue reassembling the tablet, follow the steps in reverse.

  • Be careful when reconnecting battery, use safety goggles and gloves.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • To reassemble tablet, follow these steps in reverse order.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

David Kambich

Member since: 03/11/2015

101 Reputation

1 Guide authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 186