Skip to main content

iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement

Prerequisite Only
This guide is only intended to be used as a prerequisite for other guides. It's incomplete by itself.

What you need

  1. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement, Rear Display Bezel: step 1, image 1 of 1
    • Use a 1.5mm hex screwdriver to remove the two hex screws on either side of the display (four screws total).

    • If you don't have a 1.5mm hex driver, you can probably get these screws out with a T6 Torx screwdriver. However, if you use a T6 Torx driver you'll be more likely to strip the screws.

  2. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: step 2, image 1 of 1
    • Use your thumbs to slightly separate the rear bezel from the front bezel.

    • It is helpful to hold the opposing corner of the display stationary to aid in flexing the rear bezel away from the display.

  3. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: step 3, image 1 of 3 iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: step 3, image 2 of 3 iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: step 3, image 3 of 3
    • Insert the flat end of a spudger into the gap between the front and rear bezels.

    • Rotate your spudger until it is parallel to the front face of the display.

    • Run the spudger around the perimeter of the display to separate the rear bezel from its retaining clips.

  4. iBook G4 12" 800 MHz-1.2 GHz Rear Display Bezel Replacement: step 4, image 1 of 1
    • Lift the rear bezel off the display.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 532