Fix Your Stuff

Right to Repair

Parts & Tools

iBook G4 12" 800 MHz-1.2 GHz LCD Cover Replacement

Written By: Andrew Bookholt (and 5 other contributors)
  • Comments: 1
  • Favorites: 0

Difficulty

Moderate

Steps

7

Time Required

Suggest a time??

Sections

1

Flags

1

Prerequisite Only

Prerequisite Only

Please note that this guide is only a prerequisite for other guides.

Introduction

This guide is an internal private guide that serves as a prereq.

Tools

Buy these tools

Parts

No parts specified.

  1. Remove the large piece of tape near the lower right corner of the display.

    • Remove the large piece of tape near the lower right corner of the display.

    Edit

  2. Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display (it's the first of the two clutch cover screws). Use the tip of a spudger to remove the small washer under the screw you just removed.

    • Remove the single screw inserted through the piece of EMI tape near the bottom edge of the display (it's the first of the two clutch cover screws).

    • Use the tip of a spudger to remove the small washer under the screw you just removed.

    Edit

  3. Peel the aluminum/EMI tape as one piece off the cast aluminum frame of the clutch hinges.

    • Peel the aluminum/EMI tape as one piece off the cast aluminum frame of the clutch hinges.

    • It is not necessary to peel the tape off the thin steel LCD cover.

    Edit

  4. LCD iPhone Screen Fix Kits

    The budget option, covered by our Lifetime Warranty.

    Shop Kits

    LCD iPhone Screen Fix Kits

    Cut repair costs, not quality.

    Shop Kits

  5. Remove the pieces of readily removable tape from around the perimeter of the display.

    • Remove the pieces of readily removable tape from around the perimeter of the display.

    Edit

  6. Remove the piece of aluminum tape near the center of the LCD cover. Peel back the piece of tape securing the display data cable ground loop to the thin steel LCD cover.

    • Remove the piece of aluminum tape near the center of the LCD cover.

    • Peel back the piece of tape securing the display data cable ground loop to the thin steel LCD cover.

    Edit

  7. Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total). Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).

    • Remove the two Phillips screws securing each side of the LCD to the clutch hinge frame (four screws total).

    Edit

  8. Lift the thin steel LCD cover off the LCD.

    • Lift the thin steel LCD cover off the LCD.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add a comment

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 454