Skip to main content
Help
Editing Step 1 —

Notice: You are editing a prerequisite guide. Any changes you make will affect all 2 guides that include this step.

Step Type:

Drag to rearrange

Using a screwdriver with a J000 Phillips bit, remove the fourteen 3.175 mm screws.

Using a plastic opening tool, pry part of the panel up starting from the sides of the battery slot.

Use plastic tweezers to release the rest of the panel from plastic bits holding it in place and pry the panel up around the sides surrounding the fingerprint sensor and camera lens; set the back panel off to the side.

Your contributions are licensed under the open source Creative Commons license.