Skip to main content
Help
Editing Step 1 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 12 guides that include this step.

Step Type:

Drag to rearrange

Remove four Phillips screws securing the lower display cable bracket to the logic board, of the following lengths:

Two 1.3 mm screws

Two 2.8 mm screws

Throughout this guide, keep careful track of your screws so that each one goes back where it came from during reassembly. Installing a screw in the wrong place can cause permanent damage.

Remove the bracket.

Your contributions are licensed under the open source Creative Commons license.