Skip to main content
Help
Editing Step 2 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 3 guides that include this step.

Step Type:

Drag to rearrange

While depressing the connector lock, insert the flat end of a heavy duty spudger into the gap between the power supply connector and its socket.

Twist the heavy duty spudger to slightly separate the connector from its socket.

It will be necessary to work from alternate sides until the connector is free.

Your power supply may have an ambient light sensor cable attached from the power supply to the logic board. If so, carefully use a spudger to push out the cable towards you using the sides of the cable alternatively to help you slide it out.

Your contributions are licensed under the open source Creative Commons license.